TROUBLE SHOOTING
Trouble
Probable cause
Solution
Noisly operation
Incorrect belt tension.
Dry spindle.
Lose belt or pulley
Bad bearing
Adjust tension.
Remove spindle/quill assembly and lubricate.
Tighten pulley or adjust belt tension.
Replace bearing.
Excessive drill wobble.
Bent drill.
Badly installed or loose chuck.
Badly installed drill.
Worn spindle shaft or bearing.
Replace drill.
Install the chuck correctly. Thighten by
pressing chuck down against table.
Insert the drill correctly.
Replace spindle shaft or bearing.
Motor won't start.
Power supply.
Motor connection.
Switch connections.
Motor winding burned.
Bad switch.
Check power cord.
Check motor connection.
Check switch connections.
Replace motors.
Change switch.
Drill burns or smokes.
Incorrect speed (slow down RPM).
Chips are not discharging.
Dull drill or not cut properly.
Feeding too slow.
Needs lubrication.
Feed pressure wrong.
Refer to speed chart.
Clean drill.
Check sharpness and taper, change drill.
Adjust the feeding.
Use lubrication while drilling.
Apply less pressure.
Table diffi cult to raise.
Bad lubrication.
Bent rack.
Table lock tightened.
Lubricate with light oil.
Straighten rack.
Loosen clamp.
EG 0333
DRILL Ømax 32mm 1100W 220V + VICE
