7
English
Click!
2
6
5
5. Assembly & installation
5.1 Mounting the lid
N.B.
Figures (1 – 6) only refer to the illustrations
in this section.
1. Make sure the hinge fitting (2) is completely
folded outwards.
2. Slide the lid (1) onto the hinge fitting (2), but not
all the way down.
3. First push the lid’s left pin (3) into the record player’s
left bracket (4) and then push the lid’s right pin (5)
carefully into the record player’s right bracket to
secure it (6).
4. At the same time, push the hinge fitting (2) into
the slot on the lid until it clicks into place.
N.B.
Be careful when pushing the pins into the lid brackets.
Incorrect mounting or excessive force can damage
the pins or brackets.
5.2 Connecting the speakers
Connect the right and the left speaker wires to the right
(R) and left (L) speaker outlets (31) on the back panel.
N.B.
Always have the speakers connected before
turning on the stereo system.
5.3 Connecting to the mains
1. Connect the mains lead to the mains socket on the
back of the record player (33) and plug the other
end into a power point. Check that the voltage (V),
on the rating plate on back of the device
corresponds to your local electrical network
(230 V AC, 50 Hz). Ask for advice from your
retailer or a service centre if that is not the case.
2. To completely shut off the power: Pull out the plug
from the wall socket. The device should also be
unplugged during heavy thunder storms to protect
the stereo.
Power-save mode
The record player automatically switches to
power-
save mode after 15 minutes
when the last track on
an LP, CD, USB flash drive, SD card or cassette has
been played. The record player automatically switches
to
power-save mode after 15 minutes
when it is in
pause mode (CD, USB flash drive, SD card).
To start
the record player when it is in power-save mode,
press the [ON/OFF] button twice.
5.4 Inserting batteries
1. Remove the remote’s battery cover.
2. Insert (2 × AAA/R03, 1.5 V) batteries according
to the polarity markings.
3. Push the battery cover securely back into the remote.
5.5 Placement
Place the record player on an even, hard surface.
Place it in an area where it is not exposed to possible
vibrations or knocks.
1
2
3
4
Содержание TCD-983WEC
Страница 2: ...2 ...
