3
E
N
G
LI
S
H
Programming the remote control
Entering the device code
The digits in the code are given with the help of the remote control’s buttons
according to the table:
Button
Corresponds to:
P (TV channel down)
0
P (TV channel up)
1
– (TV volume down)
+ (TV volume up)
3
1. Open the included Code list and look up under the heading for device
type which corresponds to your equipment.
TV Brands
Codes for TV devices
SAT Brands
Code for satellite and decoder
DVB-T Brands Codes for decoder for the terrestrial network
Under this heading you then search for the code which corresponds
to your brand, e.g. Philips. Each code has 6 digits. If there are several
device codes other than the one for your brand begin with the first.
. Press TV and aim the remote control towards the device you want to
control while you press and hold in
and
–
until the LED lights up.
3. Within 10 seconds, press in the 6 digit code for the device you want to
control. The LED turns immediately off.
Test the function of the remote control to the device which you have just
programmed. If the device responds correctly towards your button pressing
then you have entered the correct device code. If not, you should repeat the
procedure above with the other device codes which are available for your
brand until your device responds correctly to your button pressing and until
most of the buttons work correctly.
You also do the same thing to enter the device codes for the satellite receiv-
er (SAT) or the terrestrial decoder (DVB-T).
To do this you select which type of device to be controlled in step by press-
ing any of the buttons SAT or DVB-T instead of the TV button.
