Claro CFCLSU2LWH Скачать руководство пользователя страница 3

manufacturer, its service agent or suitably qualified persons.

20. If it is necessary to replace the live or neutral brushes to ensure operation of the motor then 

both brushes and the earth brush shall be replaced at the same time. The brushes shall only be 

replaced by a suitably qualified person.

21. An all-pole disconnection incorporated in the fixed wiring is to be provided, such as an all-pole 

switch or a supply cord fitted with a plug.

22. The light source in light kit is not replaceable; when the light source reaches its end of life the 

whole light kit shall be replaced by manufacture, his service agent or a qualified person.

23. The max operating temperature for the fan is 40 °C. Keep the fan away from any heat sources, 

like fire place, heater and stove.

IMPORTANT NOTE: 

The important safeguards and instructions given in this manual are not meant to cover all 

possible conditions and situations that may occur. It must be understood that common sense, 

caution and care are factors which cannot be built into any product.

CAUTION: 

Do not ingest battery - Chemical burn hazard. 

The remote supplied with this product contains a AAA batteries. If the battery is swallowed, it can 

cause severe internal burns in just 2 hours and can lead to death. 

Keep the new and used batteries away from children. Examine devices and make sure the battery 

compartment is secure. 

If the battery compartment does not close securely, stop using the product and keep it away from 

children. 

If you think batteries might have been swallowed or placed inside any part of the body, seek 

immediate medical attention.

Call the Poisons Information Centre on 13 11 26 or go to a hospital emergency room. 

Do not let the child eat or drink and do not induce vomiting. Dispose of used button batteries 

immediately. 

The battery supplied with this product is not to be recharged. 

Different types of batteries or new and used batteries are not to be mixed. Battery to be inserted 

with the correct polarity. + for positive, - for negative. 

Exhausted batteries are to be removed from the appliance and safely disposed of. 

If the appliance is to be stored unused for a long period, the batteries should be removed. 

Dispose of used button batteries immediately. 

Flat batteries can still be dangerous. the supply terminals are not to be short-circuited.

FAULT FINDER:

Always check the “Trouble Shooting Checklist” included in this booklet before seeking warranty 

claim.

Mechanical noise may be noticed on installation. Allow at least 8 hours settling-in period.

Some fans may wobble more than others, even if they are identical. This does not necessarily 

indicate a fault.

2

Содержание CFCLSU2LWH















Отзывы: