Clarke WOODWORKER CMS10S, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 23

FEATURES
• As its’ name implies, the machine is a Compound Mitre Saw, capable of straight
cross cutting, and cutting bevels and mitres, or a combination of the two.
• The main arm, or Cutting Head, carries the motor and the tungsten carbide saw
blade. The head, complete with table, is allowed to swivel, in both directions, to
produce mitre cuts and the head may also tilt to the left to produce bevel cuts. A
combination of swivelling head and tilting head will also produce compound mitres.
Additionally, the head is capable of moving front to rear in order to cut boards of up
to 300mm - model 10S, 310mm -12S, in width.
• The saw is also provided with a grooving facility, whereby straight or slanting
grooves may be cut - see Operation.
• The table, with head, is designed to swivel up to 45 degrees in either direction and is
provided with positive stops at 0 (90), 60, 45, 22.5 and 15 degrees.
• The maximum sizes of wood that may be cut in any of these processes is given in the
Specifications on page 2.
• A dust extraction outlet is provided at the rear of the machine, on to which the dust
bag (supplied) is fitted. If necessary, hose from a vacuum cleaner may be attached
to provide fast and efficient removal of sawdust. The vacuum cleaner may be used
continuously or intermittently depending upon your requirements.
• The blade drive shaft has a 16mm diameter. A TCT blade is provided with a bore of
1”/25.4mm. A reducer bush is therefore used, and one spare is provided.
• This saw is not designed for cutting metal, plastics or masonry.
• A motor spindle locking lever is provided - see Fig.3, used in order to remove the saw
blade.
WARNING! NEVER touch this lever when the saw is operating.
• The saw may be transported, short distances using the carry handle. Make sure
head is locked its lower position, as shown in Fig.3, and both the table locking knob
and head slide locking knob are screwed IN fully when carrying in this way.
9
Fig.3