Clarke TFC 40056380773, Инструкция по эксплуатации, Страница: 8 / 40

MAINTENANCE
1) Use only approved chemicals at the recommended mix ratios. All chemicals should be added through the feed system and NOT added
directly to the water in the solution tank to prevent possible damage to the pump, seals, or other components.
2) For optimum performance, fl ush the Chemical Feed lines after every job by replacing the chemical containers with containers of clear water
and spraying through the gun until the fl uid stream is clear. See the Maintenance Schedule, below.
3) The pump seals and/or valves in the high pressure pumps may need to be replaced after about 1000 hours of use, if the pump begins to
loose performance or to leak. The pressure regulator valve may need to be when a drop in the spraying pressure at the tool is apparent.
4) If the 4”, clear lid is removed from the top of the base (solution tank), you will need to apply a silicone sealant to the threads when you
reinstall the lid to seal for vacuum leaks.
MAINTENANCE SCHEDULE
ITEM DAILY WEEKLY QUARTELY YEARLY
Flush chemical lines X
Check/clean vac inlet fi lter X
Clean solution fi lter X
Check vacuum motor airways X
Check pump for leaks X
Check vacuum motor brushes* X
* Have Clarke check the carbon brushes once a year or after about 500 hours of operation.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
MODEL 56380773
VACUUM MOTOR: 2 stage, 8 amp
WATER LIFT: 97”
AIR FLOW: 100 CFM
TANK CONSTRUCTION: Rotationally molded polyethylene
SOLUTION TANK CAPACITY: 20 gallon
RECOVERY TANK CAPACITY: 13 gallon
APPLICATION FLOW: 400 psi
VAC & SOLUTION HOSE LENGTH: 25 feet
POWER CORD: 25 feet
HEIGHT: 38.5 inches
WIDTH: 21.25 inches
LENGTH: 34 inches
WEIGHT 92 LBS
A-8 TFC 400 - 56380889 11/09
INSTRUCTIONS FOR USE A - ENGLISH