Clarke Strong-Arm 7610500, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 10

7. Use appropriate safety equipment, such as protective footwear, when using
this crane.
8. Ensure the crane operator is skilled and trained in both operation and safety
aspects.
9. Always inspect the crane before use to ensure it is in good condition, and
replace any damaged or worn parts.
10. When replacing parts, use only those supplied by Clarke International. Refer
to Parts List.
11. Ensure that the crane is properly maintained, and lubricated at all times, and
that no rust or other forms of corrosion is allowed to weaken any part of the
crane.
12. If the crane has been subjected to an abnormal load or shock, it should be
removed from service immediately and fully inspected by qualified personnel.
Preparation For Use.
Figures in brackets refer to parts list on page 7.
The crane is packed, fully assembled, in the fully folded position. On unpacking
check to ensure that no damage occurred during transit, and that all parts are
present according to the packing list.
1. Withdraw the locking pins (Item 21), lower the legs, and lock in position with
the same pin, securing with the ‘R’ clip (Item 20).
2. Release the stabilising foot (Item A), by removing the ‘R’ clip (Item 19), and
rotating the foot so that it faces upwards. Secure in position with ‘R’ clip.
3. Before operating the crane, remove the transit plug from the back of the
hydraulic ram unit , and replace with the vent plug supplied. retain the transit
plug which should be re-fitted if the crane is stored or transported horizontally.
3. Test the operation of the crane without a load (refer to ‘Operation’ for raising
and lowering the jib). If the ram operation appears ‘spongy’, it is possible that
air may have entered the system. Raising the lowering the jib a few times will
dispel any air and normalise the ram operation.
If the jib does not reach its full height, the rams hydraulic oil may need topping
up, (ref ‘Maintenance’).