EN
ENGLISH
-8- FORM NO. 71280A
Clarke
®
Operator's Manual (EN) - Ultra Speed Burnisher
HOW TO OPERATE THE MACHINE
WARNING: Machines can ignite
fl
ammable materi-
als and vapors. Do not use with or near
fl
ammables, such as: gasoline, grain
dust, solvents and thinners.
CAUTION: Allowing the machine to run without
moving forward or backward can cause
serious damage to the
fl
oor surface.
Make sure the machine is always mov-
ing when the pad is rotating.
NOTE: You must have training in the operation of this
machine before you use it.
How To Start/Stop The Machine
WARNING:
Never start a burnisher when the
handle is in the vertical position.
The switch to start and stop the machine is activated
by the interlock (1) and the levers (2) under the handle grips.
See Figure 3.
To start the machine, follow this procedure:
1. Depress the handle release lever with your foot and
lower the handle.
NOTE: Make sure you hold the handle with both hands.
2. Continue to move the handle to the rear until the
handle is in the operating position. The handle
moves freely up and down when it is in the operating
position.
3. Push the interlock switch (1), and apply pressure
to one of the levers (2). See Figure 3.
4. Push the machine forward on the
fl
oor. Move the
machine slow on dirty surfaces. Move the machine
faster on cleaner surfaces.
How To Change the Dust Collection Bag
The dust collection bag (see
fi
gure 4) should be replaced after
every 10 hours of use. Tip the machine back onto it’s handle.
Squeeze in on the sides of the bag cover and remove it from
the machine. Remove the dust bag and discard. Push in on
the sides of the new bag to pop-it-open and install it by pushing
it down onto the tubes protruding from the base. Re-install the
cover and tip the machine back upright.
Figure 3
n
n
n
1
2
2
Figure 4
Cover
Bag
https://harrissupplyind.com - To Order Parts Call 608-268-8080
