Clarke Power Wash PLS190, Инструкция по эксплуатации и техническому обслуживанию, Страница: 15 / 28

15
APPLYING CHEMICALS AND CLEANING SOLVENTS
1. Push the chemical hose onto the
barbed fitting located near high
pressure hose connection of
pump as shown.
2. Place other end of chemical hose
with filter on it into container
holding chemical/cleaning
solution.
3. Slide the nozzle forward for low
pressure.
• The water/chemical ratio is 7:1, for every 7 gallons of water pumped
1 gallon of chemical/ cleaning solution will be used.
SHUTTING DOWN
1. After each use, if you have applied chemicals, place chemical hose into
container of clean water and run clean water through chemical injection
system to flush the system thoroughly.
NOTE: Failure to do so could cause damage to the pump.
2. Turn engine off. See engine owner's manual.
NOTE: NEVER turn the water off with the engine running.
3. Turn water source off.
4. Pull trigger on spray gun to relieve any water pressure.
5. See storage section in this manual for proper storage procedures.