Clarke Power Wash PLS190, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 28

11
3. If the oil is low fill the oil reservoir to
the edge of the oil filler hole.
• We recommend the use of
SAE30 oil in this power washer.
4. Replace the oil filler cap.
NOTE: Running the engine with
insufficient oil can cause
engine damage.
CHECKING THE FUEL LEVEL
1. To check the fuel level open the fuel tank cap.
2. Just inside the fuel tank is a fuel strainer, check this filter periodically and
remove any contaminants which may have accumulated.
3. Refuel in a well-ventilated area.
Before starting the engine. If the
engine has been running, allow it
to cool. Refuel carefully to avoid
spilling fuel. Do not fill above the
fuel strainer shoulder.
4. After refueling, tighten the fuel
tank cap securely.
5. Replace the fuel filler cap securely.
RECOMMENDED FUEL
Use unleaded petrol with a pump octane rating of 86 or higher. Do not overfill .
PRESSURE REGULATOR
When supplied the pressure regulator
may be set to minimum.
Turn the pressure regulator on the
pump fully clockwiseto allow water
pressure to build up when the
pressure washer is running.
If you find the pressure is too high, you
can adjust this later.
WARNING: ALWAYS REFUEL IN A WELL VENTILATED AREA AWAY FROM
ANY HEAT SOURCES.
WARNING: ALLOW THE UNIT TO COOL DOWN BEFORE REFUELLING.
WARNING: DO NOT LEAVE FUEL WITHIN THE REACH OF CHILDREN.