Clarke PIONEER 220, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 24

12
• The ON/OFF switch is in the OFF
(depressed) position.
• The pressure regulator should be
set at its lowest setting, i.e.
turned fully anticlockwise. (- & +
arrows are shown on the knob)
• If the compressor has not been
used recently, open the drain
valve shown in Fig 1 to drain any
condensate which may have
accumulated. When clear, close
the valve, finger tight.
IMPORTANT: If the receiver is under pressure, keep your hands well away
from the air being expelled. Remember, compressed air is DANGEROUS!
WARNING! Before connecting any air tool, make sure you have
read and fully understood the manufacturer’s instruction booklet
for the air tool being used. Also ensure that the tool is compatible
with the compressor and hose specifications.
If the pressure rating of the tool is less than 8 bar, the pressure
regulator must be used to adjust the output pressure.
1 Connect a suitable air hose to the
compressor outlet and the other
end to the equipment to be used.
Attach the air hose to the outlet
connector using the quick-release
fitting as shown in Fig 2.
2. Plug in the machine and switch ON
at the mains supply.
Fig 2
Fig 1