Components
A
Tray with Castors
1
B
Tray
3
C
Column
1
D
Split Roll Pin
4
E
Tray Support
3
F
Plastic Cap
1
Assembly
If the castors are not fitted, slide them into the holes provided in the relevant tray
and secure with the screw supplied.
Slide the Column into thehole in the centre of the tray with castors and secure
with the screws provided.
Tap a Roll Pin into the lowest of the holes in the column until it is centralised, then
place the Column Support (large washer) so that it rests against the pin. Lower a
tray on top of the support.
Repeat this procedure fot the two remaining trays, and finally push the plastic
cap into the top of the column.
Your Carousel is now ready for use.
Components
A
Tray with Castors
1
B
Tray
3
C
Column
1
D
Split Roll Pin
4
E
Tray Support
3
F
Plastic Cap
1
Assembly
If the castors are not fitted, slide them into the holes provided in the relevant tray
and secure with the screw supplied.
Slide the Column into thehole in the centre of the tray with castors and secure
with the screws provided.
Tap a Roll Pin into the lowest of the holes in the column until it is centralised, then
place the Column Support (large washer) so that it rests against the pin. Lower a
tray on top of the support.
Repeat this procedure fot the two remaining trays, and finally push the plastic
cap into the top of the column.
Your Carousel is now ready for use.
