Clarke Metalworker CDP501F, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 23

9
ASSEMBLY
CAUTION!
DO NOT ATTEMPT TO ASSEMBLE THIS MACHINE SINGLE HANDED..ASSISTANCE MUST BE USED
A. Column Assembly to Base
( Ref Parts List/Diagram page 18)
NOTE: Ideally, the base should be firmly bolted to the floor prior to assembly of other
components. The mounting surface must flat, level, and capable of supporting the weight
of the drill plus anticipated work.
With the Base on a flat level surface, bolt on the Column Support (8) complete with Column
and Table Support, using the 4, M12 Hex head screws (9) provided, and tighten them fully.
B. Mounting the Table Assembly
1. From the box of loose parts, locate the worm,
and install it in the Gear Housing of the Table
Support, liberally greased and pushed fully
home.
2. Push the the crank on to the worm spigot,
protruding from the gear housing, as far as it
will go and tighten the crank’s grub screw on to
the flat on the spigot.
3. Screw the crank handle into the crank and
tighten fully.
4. Slacken the Collar grub screw (see fig.2),
using the 3mm hex. wrench provided, and
remove the Collar and Rack from the Column.
5. With assistance, raise the table and insert the
rack into the Gear Housing with the long
smooth end uppermost, as shown in fig. 3,
and engaged with the gear within the
housing.
6. Lower the complete assembly down on to the
Column so that the lower end of the rack rests
in the ‘vee’ created between the Column
Support and the Column, then screw in and nip
up the Table Support Locking Handle to secure
the table temporarily in this position.
7. Slide the top collar back into place and tighten the grub
screw, ensuring there is sufficient clearance between the
collar and the Rack to allow the Rack to move smoothly
within the Collar (as the table swings around the column),
without appreciable slack. It will be necessary to slacken
the Table Support Locking Handle to test its operation.
Check also to ensure the table moves smoothly and freely
from top to bottom of the Rack, by winding the crank.
Fig. 1
Fig. 2
Fig. 3