Clarke Metalworker CDP501F, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 23

10
C. Head to Column Fig. 4
Fig. 5
NOTE : It may be necessary to unscrew the Head
Lock Set Screws (A, fig.4) slightly, to ensure they
do not protrude internally as this would prevent
the head from sliding fully into position.
1. With assistance, raise the head and locate it
on top of the Column.
2. Align the head with the base, and firmly
secure with the set screws provided, (A-
Fig.4).
3. Locate the three feed handles (items 18 & 19
page17),and screw them firmly into the hub
of the spindle feed shaft (item 20, page 17).
D. Chuck Guard Assembly
.
NOTE: This operation should be carried out before the
chuck is installed.
Slide the Chuck Guard over the Quill Shaft, turn it so that
the pinch bolt faces the front (as shown in fig.5), then nip
up the pinch bolt to temporarily secure it in this position.
IMPORTANT: Ensure the Quill Shaft/Spindle is at the top of its
travel.
E. Installing the Chuck.
1. With the chuck guard lifted clear of the spindle nose, wind the table up the column
and secure it to within 6" of the spindle.
2. Open the jaws of the chuck to their maximum, using the chuck key supplied.
3. Put a piece of scrap wood on to the table to protect the chuck nose.
4. Ensuring all parts are thoroughly clean, dry, and burr free, Slide the arbour into the Quill
and push home, turning as you do so, to ensure the tang, on its end, seats correctly.
Place the chuck over the end of the arbour and pull the spindle down using the feed
handles, pressing the chuck jaws hard against the piece of scrap wood until the chuck
is forced home. (Fig.4).
F. Fitting the Drive Belts.
1. Undo the Belt Tension Lock Knobs (one
either side of the head - A-Fig.6), and
turn the Belt Tension Lever (B) clockwise
to bring the Motor Pulley closer to the
Spindle Pulley. This will allow the belts to
be slipped on with ease.
2. Lubricate the Idler Pulley Pivot shaft (item
4, page 19) and Idler Pulley, with light
grease and install in its’ mounting
between the Motor and Spindle Pulleys.
Fig.6
3. Consult the chart inside the belt cover (duplicated on page 14), and fit the belts in the
positions corresponding to spindle/drill speed required.