Clarke METALWORKER CDP201B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 21

E. Installing the Chuck.
1. Slide the table up the column and secure it to within 6"
of the spindle.
2. Open the jaws of the chuck to their maximum, using
the chuck key supplied.
3. Put a piece of scrap wood on to the table to protect
the chuck nose.
4. Ensuring all parts are thoroughly clean, dry, and burr
free, place the chuck over the end of the spindle, and
pull the spindle down using the feed handles, pressing
the chuck jaws hard against the piece of scrap wood
until the chuck is forced home. (Fig.4).
5. Turn Chuck Guard through 180° and tighten pinch bolt.
Fig. 4
1. Undo the Belt Tension Locking
Screws (one either side of the
head - A Fig. 5), and turn the
Belt Tension Lever (B - Fig. 5),
clockwise to bring the Motor
Pulley closer to the Spindle
Pulley which will allow the belts
to be slipped on with ease.
2. Lubricate the Idler Pulley Pivot
shaft with light grease and
locate in its’ mounting between
the Motor and Spindle Pulleys.
3. Consult the chart inside the belt cover (duplicated on page 12), and fit the belts in the
position corresponding to spindle/drill speed required.
4. Turn the Belt Tension Lever (B) anti-clockwise so that tension is applied to the belts.
Tension is correct when the belts deflects by approx. ½” at their centres of run when
using reasonable thumb pressure. Lock the motor in this position with the Locking
Screws - A.
NOTE:
1. The idler pulley will ‘float’ so that tension is applied equally to both belts
2. If the belt should slip whilst drilling, adjust the belt tension.
CHECKING THE OPERATION OF THE MICROSWITCH
IMPORTANT:
When closing the cover, check the operation of the Microswitch. It is important that it
operates immediately the cover is pulled open, in order to prevent the machine from
operating........NOT when the cover is opened sufficiently for fingers to be inserted.
If necessary, bend the actuating tab, which is attached to the cover, to ensure this.
Fig.5
F. Fitting the Drive Belts
.
10