3
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
A 12mm hole is provided on the end of each foot to allow the stand to be
anchored to the floor. Ensure the floor is level before the stand is secured.
Site the grinder in a well lit area, where you will not be working in your own
shadow.
Ensure an adequate electrical supply is close at hand - avoid long extensions
which are a hazard in a workshop environment.
The bench grinder should be mounted with its centre of gravity as near to the
centre of the table as possible.
Ensure that the correct size bolts (from those provided) are used for the size of
holes in your grinder mountings, and that flat washers are used to
compensate for the oversize holes in the table.
The nuts should be nipped up firmly, but be careful not to overtighten them.
Cable
retaining
hook
Upper Column
Stop Screw
Socket head
screw
Upper column
Lower column
Base
Spring washer
Grinder mounting table
Tensioning knob
M10 x 10 setscrews
Storage shelf
Wheel storage box
Flat washer
Small screw
Hex head bolt &
flat washer
Self-tapping screws
Positioning Slots
