Clarke LOGBUSTER 5, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 16

12
MAINTENANCE
REPLACING THE HYDRAULIC OIL
Replace the Hydraulic oil in the log buster after every 150 hours of use. Take
following steps to replace it.
1. Place a container, large enough to hold 4
liters of oil under the oil filler plug, Loosen
the bleed screw three or four turns.
2. Loosen and remove the oil filer plug/
dipstick, slowly tilt the machine to empty
the oil.
3. To refill with new oil, tilt machine
backwards, using a clean funnel, pour in
3.5 Liters of Clarke hydraulic oil,
IMPORTANT: Only use CLARKE HYDRAULIC
OIL, available from your nearest dealer.
Part No: 1Ltr - 3050830
5Ltr - 3050835
4. Wipe the dipstick, using a clean soft cloth
and check the oil level as before
• Add more oil if required.
5. Clean the filler neck and plug/dipstick
washer/seal thoroughly and refit, tighten
sufficiently to prevent oil leaking, DO NOT
overtighten.
6. Carefully return the machine to normal working position.
7. Finally, tighten the bleed screw.
SHARPENING WEDGE
After using the log busters for some time, sharpen the wedge of the log buster
using a fine-toothed file and smooth any burrs or crushed area along the
cutting edge.
WARNING: MAKE SURE THAT THE LOG SPLITTER IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY
CLEANING OR MAINTENANCE PROCEDURES.