ELECTRICAL CONNECTIONS
11
The machines are delivered for connection
to a 400V supply, but to be certain, check the
label on the end of the power supply cable,
or remove the cover and visually inspect the
Voltage changeover block. (see fig. 4).
If the supply voltage is changed, a
corresponding change must be made to the
terminal connectors on the ‘Voltage
Changeover’ block, located behind the right
hand side panel, as follows:
1.
Ensure the machine is switched OFF, and
completely disconnected from the
electrical supply, or if hard wired, the
fuse should be removed from the circuit.
2.
Remove the right hand side panel by
unscrewing the 6 securing screws.
3.
Change the connections of the ‘Voltage
Changeover’ block, as shown on the
label inside the unit, which is duplicated
above at fig 4.
A. KING 35 & KING 50
Connect the mains lead, through a suitably fused isolator switch, to a 230 Volt (50Hz)
electrical supply, having a fuse rating in accordance with that given in the specification
chart on page 2. A standard 13 Amp plug
MUST NOT
be used with this machine.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow
- Earth
Blue
- Neutral
Brown
- Live
As the colours of the flexible lead of this appliance may not correspond with the
coloured markings identifying terminals in your electrical supply, proceed as follows:
•
Connect GREEN & YELLOW coloured cord to terminal marked with a letter “E” or Earth
symbol “ ” or coloured GREEN or GREEN & YELLOW.
•
Connect BROWN cord to terminal marked with a letter “L” or coloured RED.
•
Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.
B. KING 70
This model is designed for use with either
230V three phase or 400V three-phase
supply, and should be connected through a suitably fused isolator switch.
The GREEN or GREEN & YELLOW wire should be connected to the EARTH terminal
or terminal marked with “ ” symbol. The other two wires are for connection to
the phase wires.
Fig. 4
CAUTION: Never operate the
machine with the panels removed.
