Clarke KING 145, Инструкция по эксплуатации и обслуживанию

Страница: 14 / 24

14
EVERY 2 WEEKS OR 50 WORKING HOURS
Check the filter in the water inlet connection (A) fig. 14.
CLEANING THE WATER INLET FILTER
This screen filter should be checked periodically and cleaned if necessary.
1.
Fig. 14
Remove filter from the water inlet
as shown.
2. Clean filter by flushing from both
sides with water.
3. Replace the filter into the water
inlet.
Do not operate power washer
without filter installed.
EVERY 4 WEEKS OR 100 WORKING HOURS:
1.
Fig. 15
Unscrew the two screws indicated
and lft off the outer cover.
2. Pull off the 2 spark plug leads.
3. U
Fig. 16
nscrew the three blind nuts
shown and cadefully lift off the
cover plate taking care not to
damage the fuel pipe.
4. Check the gap between the
electrodes.
• The gap should be 3 mm.
• Wipe the electrodes clean.
5. Reassembly is the reverse of the
removal procedure .
WARNING: BEFORE DOING ANY WORK ON THE POWER WASHER,
DISCHARGE THE PRESSURE FROM THE HOSE AND DISCONNECT THE
ELECTRICITY SUPPLY PLUG, REMOVE THE HOSE FROM THE TAP TO
DISCONNECT THE WATER SUPPLY.