13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
CLEANING THE NOZZLE
If the nozzle becomes clogged with foreign materials such as dirt or calcium,
excessive pressure may develop. If the nozzle becomes partially clogged or
restricted, the pump pressure will pulsate, clean the nozzle immediately by
following the instructions below:
1. Turn off the pressure washer and
turn off the water supply.
2. Pull trigger to release any water
pressure in the hose.
3. Disconnect the lance from the
gun.
4. Remove any obstructions with the
nozzle cleaning tool provided.
5. Direct water from a tap into the
end of the lance for 30 seconds to back flush loose particles.
6. Reconnect the lance to gun and turn on water supply.
CLEANING THE WATER INLET FILTER
This filter should be checked periodically and cleaned if necessary.
1. Remove the inlet filter from the
pressure washer as shown.
2. Clean the filter by flushing both
sides with water.
3. Replace the filter into the water
inlet.
• Tapered side faces in.
NOTE:
Do not operate the pressure
washer without filter installed.
WARNING: THE PRESSURE WASHER SHOULD BE DISCONNECTED FROM THE
MAINS POWER SOCKET DURING CLEANING OR MAINTENANCE.
