Page -14-
Clarke
®
Operator's Manual IMAGE 26E
After Each Use of the Machine
1. Disconnect the power cord from the outlet.
2. Drain and rinse out the recovery and the solution tank
following this procedure:
For Recovery Tank
a. Position the machine close to a floor drain or an
appropriately sized bucket or container.
b. Remove the hose from the fitting on the back of
the machine.
c. Put the end of the hose over a drain or bucket.
d. Open the drain plug latch to release and drain
tank.
For Rinse Tank
a. Remove clear hose from top connector.
b. Position in appropriate container or floor drain.
c. Drain tank.
*TIP: To drain, disconnect from top plug and insert
into vacuum hose up to the adaptor. Turn vacuum on.
Empty recovery tank.
NOTE: Make sure to drain both the recovery tank
and the rinse tank. For chemical tank, solution
should be emptied into proper storage container.
Remaining soap in line must be removed by running
water through rinse tank.
3. Use a clean dry cloth to wipe out both tanks and the
recovery tool, both inside and out.
4. Leave the tanks and drain hoses open to dry in the air.
5. Inspect and clean the filter screen between the
solution tank and pump.
6. Inspect and clean the prespray jets and the rinse jets.
After Cleaning the Carpet
1. Do not walk or place heavy objects on the carpet for
at least four hours or until the carpet is dry to the
touch.
2. Vacuum right after the carpet is dry and vacuum at
least once a week, or as often as needed.
CAUTION:
You are responsible for Operator
error. Clarke will not be held
liable for damage to the carpet
or for poor results because of the
operator's errors.
3.
To speed drying time of the carpet try a Clarke Direct
Air carpet dryer.
MACHINE OPERATING INSTRUCTIONS
https://harrissupplyind.com - To Order Parts Call 608-268-8080