Page -10-
Clarke
®
Operator's Manual IMAGE 26E
115V Electrical Connection Instructions
DANGER:
Electrocution and/or damage could
occur if this machine is plugged
into anything other than the cor-
rect frequency as specified on the
nameplate. This machine will
operate only on AC frequency and
on electrical voltage shown on the
nameplate. Make sure you have
the correct frequency and voltage
before connecting the power cord
to an outlet. The machine has a
plug as shown in figure 8.
This machine must be connected to an electrically
ground circuit in order to protect the operator from
electric shock. This machine has an approved power
cord with three conductors as well as a plug with three
terminals. Connect the plug into a three holed receptacle.
For maximum protection against electric shock, use a
circuit that is protected by a ground fault circuit interrupter.
This machine uses a 115V AC 60 cycle electrical circuit.
Make sure you have the correct frequency and voltage
before connecting the power cord to an outlet. Do not
use an adaptor to plug in this machine. Contact an
electrical contractor and have a 3-prong receptacle
installed.
DANGER:
Electrocution could occur if the
machine is exposed to water or
rain. Keep the machine in a dry
building.
DANGER:
Electrocution could occur if ma-
chine is improperly connected to
the electrical system. To prevent
possible electric shock, always use
a 3-wire electrical system con-
nected to an electrical ground.
For maximum protection against
electrical shock, use a circuit that
is protected by a ground fault cir-
cuit interrupter. Consult your elec-
trical contractor.
DANGER:
Electrocution could occur if the
ground pin is tampered with in any
way. Do not cut, remove, or break
the ground pin. Do not try to fit a
three-terminal plug into a recep-
tacle or connector body other than
a three plug receptacle or connec-
tor body. If the outlet does not fit
the plug, consult your electrical
contractor.
DANGER:
Electrocution could occur if the
machine is used with a damaged
plug or power cord. If the cords or
plugs are worn or damaged in any
way, have them replaced by an
authorized service person or elec-
trician.
Figure 8
Ground Pin
Outlet
must be
connected
to the
electrical
ground
Plate
Screw
https://harrissupplyind.com - To Order Parts Call 608-268-8080