Clarke Image 26B, Руководство оператора, Страница: 7 / 40

Clarke
®
Operator's Manual IMAGE 26B Page -7-
Key Switch (See figure 1, A)
The key switch is located on the control panel.
The key switch must be on before any
function of the machine will work.
Turn to "O"
for OFF and "I" for ON.
Battery Meter (See figure 1,B)
The battery meter indicates the relative charge on
the battery pack. Do not continue to run the
machine when the meter is in "red" area. This will
shorten the life of the battery.
NOTE: Low voltage
will shut off solution and brush functions. Recover
remaining solution and return to charge station.
The Traverse Knob (See figure 2, A)
The traverse knob is located on the left side of the
control panel. The traverse knob controls the speed of
the machine. For faster speeds, turn the knob to the
right. For slower speeds, turn the knob to the left.
Light bars indicate traverse speed. Twenty feet per
minute is optimum cleaning speed.
The Traverse Meter (See figure 2, B)
The lights on the meter indicate the cleaning range.
Speeds in the 1 to 10 light range indicate cleaning
speeds for various conditions. Speeds above those
indicated by the tenth light are used only for traversing
to dumping, filling or charging locations.
Variable Pump Pressure (See figure 2, C)
The control knob is located on the right side of the
control panel. The control knob can be adjusted clock-
wise to increase flow and pressure or counterclock-
wise to decrease flow and pressure. If streaking
occurs increase pressure setting.
WARNING: Do not operate the pump if the
solution tank is empty. Damage to
the pump could occur.
The Vacuum Switch
The vacuum switch is activated by the recovery tool lift
handle. The vacuum motors are switched on when the
tool is lowered. The vac motors are switched off after
a 10 second delay when the tool is raised.
Accessory Vac Switch (See figure 3,A)
The accessory vac switch is located on the lower left
side of the control panel. This switch turns on the vac
motors when the recovery tool is raised. This allows the
use of accessory tools when connected to the recovery
hose.
Pump Switch (See figure 3,B)
The pump switch allows the pump to be turned off when
solution application is not required.
Figure 1
Figure 2
Figure 3
THE CONTROLS
A
A
C
A
B
B
B