Clarke Image 26B, Руководство оператора, Страница: 15 / 40

Clarke
®
Operator's Manual IMAGE 26B Page -15-
After Each Use of the Machine
1. Turn main power switch to off position.
2. Drain and rinse out the recovery and the solution tank
following this procedure:
For Recovery Tank
a. Position the machine close to a floor drain or an
appropriately sized bucket or container.
b. Remove the hose from the fitting on the back of
the machine.
c. Put the end of the hose over a drain or bucket.
d. Twist drain plug cap to release and drain tank.
For Solution Tank
a. Remove clear hose from top connector.
b. Position in appropriate container or floor drain.
c. Drain tank.
NOTE: Draining process can be expedited by
removing vac hose from recovery tool and inserting
solution drain hose. Start vac motor after inserting
hose. (See figure 17)
NOTE: Make sure to drain both the recovery tank
and the solution tank.
3. Use a clean dry cloth to wipe out both tanks and the
recovery tool, both inside and out.
4. Leave the tanks and drain hoses open to dry in the air.
5. Inspect and clean the filter screen between the
solution tank and pump.
After Cleaning the Carpet
1. Do not walk or place heavy objects on the carpet for
at least four hours or until the carpet is dry to the
touch.
2. Vacuum right after the carpet is dry and vacuum at
least once a week, or as often as needed.
CAUTION: You are responsible for Operator
error. Clarke will not be held
liable for damage to the carpet
or for poor results because of the
operator's errors.
3. To speed drying time of the carpet try a Clarke Direct
Air carpet dryer.
MACHINE OPERATING INSTRUCTIONS
Figure 17