Clarke DG6000DVES, Инструкция по эксплуатации и техническому обслуживанию

Страница: 30 / 36

30
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
TROUBLESHOOTING
Problem Cause Solution
Engine will not
start No fuel in engine Turn fuel valve to “open” position
(handle pointing down)
Air trapped in the fuel line Bleed fuel line
Generator is out of fuel Add fuel
Not enough oil in crankcase Add or replace oil
Low-oil sensor failure Add oil, disconnect low-oil sensor, start
engine and let run for several minutes,
then reconnect the sensor
Generator is not on level
surface Move generator to a level surface to
prevent low oil shutdown from
triggering
Load was connected to the
generator Disconnect all load devices from the
generator
Air cleaner is dirty Replace air cleaner element
Battery is discharged Charge the battery for 2 hours.
Battery is dead Replace the battery
Engine needs maintenance Get a professional engine tune-up
Engine stops
automatically Generator is out of fuel Add fuel
Fuel line is obstructed Clean fuel tank and fuel filter. Bleed fuel
line
Air filter is dirty Replace air filter element
Sudden increase to electrical
load. Decrease the load
Black smoke
from exhaust Generator is overloaded Decrease load
Oil in cylinder Check oil level, drain excessive oil from
crankcase
Not enough air or leaking air. Replace air cleaner element, check
and fix air leakage.
Fuel injection malfunction Check injection pressure and spray
condition, change nozzle, or call
technical support.
White Smoke
from exhaust There is water in diesel fuel Clean the fuel tank and fuel filter.
Change diesel fuel