10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
.
The thermal cutout may also operate if the heater is shut down without
allowing to cool sufficiently. If subsequently, the heater fails to start, press the
RESET using a suitable tool and try again.
MAINTENANCE
If the heater has been used, ALWAYS allow it to cool down for at least 10
minutes (by switching the heater off, but leave the fan running). Always
disconnect from the mains supply before performing any maintenance tasks.
PERIODICALLY
1. Use compressed air to clean out the unit. Always wear a dust mask to
perform this operation.
2. If there is any serious build up of dirt, wipe thoroughly with a damp cloth.
Take care that no moisture enters the heater.
3. Inspect the mains cable for damage. Heat damage will cause the cable
to stiffen and crack. If this is found, have the cable replaced. Check the
cable routing and ensure it is well away from the heat source.
4. Ensure the heating elements are clear of dust (use compressed air to clean
the heater if possible).
5. Avoid using solvents when cleaning plastic parts, most plastics are
susceptible to damage from various types of commercial solvents.
6. Refer to your Clarke dealer if internal maintenance is required. The unit is
fitted with tamper-proof screws to discourage users from dismantling the
heater.
7. When storing the heater, allow it to cool down, and return it to its own
packaging for storage in a dry, well ventilated place.
Содержание Devil 6003
Страница 20: ......
