4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SAFETY PRECAUTIONS
1. Always read the instructions before assembling the unit.
2. Periodically inspect the unit to ensure it is in good condition, replace any
damaged parts.
3. If replacing any parts, only use those supplied by Clarke International,
referring to the parts list on page 3.
Please keep these instructions in a safe place for future reference.
ASSEMBLY
Unpack the parts on to a clean flat area and visually inspect components to
ensure that no damage was suffered in transit, identifying them according to
the parts list and diagram opposite.
Should any damage be apparent, please contact your Clarke dealer.
NOTE: All screw heads should be on the outside of the cabinet. DO NOT
tighten any nuts until the cabinet is fully assembled.
1. Hold the back panels as shown in
Fig 1, with the left/right hand
dividing panels slotted between.
• Ensure that all three back
panels are the same way up
and check the slotted holes are
oriented as shown.
• Ensure that the dividing panels
have their flanges facing each
end of the assembly to create
the closed cupboard sections.
Note that
the back panels are of a
folded box section. The folded edges
should be towards the rear of the
cabinet.
2. Line up the holes and insert an M5
bolt at each of the four locations.
Secure with an M5 washer and
nut as shown in Fig 2.
Содержание CWC50
Страница 8: ......