Clarke CUTS1, Руководство по сборке

Страница: 5 / 8

Assembly
cont.
1. Place the frame on the floor in the
inverted position, i.e. legs
uppermost, and raise the legs, so
that the brace may be fitted, using
two large lock knobs - one at each
end, as shown in Fig. 2.
4
2
2. Attach the stabilisers, one to each leg, as shown in Figs 3 and 4.
The locating peg, in the leg cross member, should sit snugly in thre hole in the
stabiliser, and the stabiliser secured using two countersunk screws with self
locking nuts supplied.
3
3. Raise frame to its upright position. The height may be adjusted by undoing
the large knobs securing the telescopic legs and locating at the desired
position using the pins provided. Tighten the locking knobs securely.
4. Place the Tool Supports on the frame but
do not tighten the clamps. Two carriage
bolts should be slid into the groove of
each clamp as shown in Fig.5.
The tool (Mitre Saw etc.) is placed on the
tool supports so that the carriage bolts
enter the holes in the base of the tool.
The flat washer and lock nuts are then
5
screwed on andf tightened to secure the tool.
Finally, tighen the tool support clamps using the handles to do so.
5