20
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CROSS CUTS
1. Slide the mitre gauge into one of
the grooves in the table.
2. Adjust the mitre gauge to the
required angle.
3. Press the workpiece firmly against
the mitre gauge.
4. Switch on the saw.
5. Push the mitre gauge and the
workpiece toward the blade to
make the cut.
IMPORTANT: Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
6. Push the mitre gauge forward until the workpiece is cut all the way
through.
7. Switch off the saw. Do not remove the offcut until the blade has stopped
rotating.
TRANSPORTING
1. Turn the table saw off and disconnect it from the power supply before it is
moved
2. At least two people should carry the saw. Do not lift using the table
extensions. only use the hand holds for moving this table saw. These are
punched into the housing on both sides of the main body.
3. Protect the saw against knocks, jolts and strong vibrations. e.g. when it is
transported in motor vehicles.
4. Secure the saw against tilting and sliding.
5. Never hold the blade guard when lifting the table saw.
STORAGE
• Store the appliance in a dry place well out of reach of children.
Содержание CTS15
Страница 1: ...OPERATION MAINTENANCE INSTRUCTIONS LS1116 10 TABLE SAW MODEL NO CTS15 PART NO 6500747...
Страница 28: ......
