Install the new shock absorber installed, and ensure the securing nut is tightened
according to manufacturers instructions before turning the actuator knob
anticlockwise so that the ram extends, allowing the coil spring to reassert so that
the complete assembly may be removed from the compressor.
4
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
PARTS AND SERVICE CONTACTS
If performance begins to decline, bleed the pump as follows:.
1.
Tighten ( turn clockwise) the actuator knob on the pump while the
pump hose is still attached to the main assembly.
2.
Remove the oil filler cap, then pump the handle slowly to bleed air
from the system. Repeat until no air is expelled
3.
Add clean, high quality hydraulic oil if necessary and then replace
the oil filler cap.
4.
Test the pump by tightening the actuator knob and pump the handle.
The spring Compressor should operate satisfactorily. If it does not
performing properly, repeat the bleeding procedure.
MAINTENANCE
Parts - RAM
Item
Description
Qty
Part No.
1.
Screw
1
SNCSC100001
2.
Spring
2
SNCSC100002
3.
Nut
1
SNCSC100003
4.
Bushing
1
SNCSC100004
4a.
Sealing Ring
1
SNCSC100004a
5.
Retaining Ring
1
SNCSC100005
6.
Piston Rod
1
SNCSC100006
7.
Cylinder
1
SNCSC100007
8.
Cylinder Screw
1
SNCSC100008
9.
Connection Nut
1
SNCSC100009
10.
O-Ring
2
SNCSC100010
60.
Claw Set #1 (170mm)
1
SNCSC100060
61.
Claw Set #2 (130mm)
1
SNCSC100061
62.
Hand Pump
1
SNCSC100062
5
