14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BELT TRACKING
The belt-tracking adjustment is set at the factory so that the abrasive belt will
run true on the drums. If, however, the belt should track to one side or the
other, an adjustment can be made by turning the tracking knob.
TO TRACK THE SANDING BELT
1. Use your hand to roll the belt
towards the belt sander table.
• If the sanding belt does not
move to either side after several
full turns, it is tracking correctly.
• If not adjust the belt tracking
dial slightly and roll the belt
again.
• Repeat as necessary.
NOTE:
Do not make large adjustments to the belt tracking dial and remember
it may take some time for the belt to react to any change you make.
MAINTENANCE
1. Clean the machine, belt and disc after each use.
2. Keep the machine dry, clean and free of oil and grease.
3. Keep the machine in a safe and dry area, out of reach of children.
4. During use, sanding belts and discs can become dirty with sanding debris.
Use a stick belt cleaner (available at most hardware stores) to remove
unwanted material from the belt/disc.
WARNING: ALWAYS DISCONNECT TOOL FROM POWER SOURCE BEFORE
MAKING ANY ADJUSTMENTS, INSTALLING OR PERFORMING
MAINTENANCE.
CAUTION: TOOL SERVICING MUST BE PERFORMED ONLY BY QUALIFIED
REPAIR PERSONNEL. SERVICE OR MAINTENANCE PERFORMED BY
UNQUALIFIED PERSONNEL COULD RESULT IN A RISK OF INJURY. WHEN
SERVICING A TOOL, USE ONLY IDENTICAL REPLACEMENT PARTS.
CAUTION: FOLLOW INSTRUCTIONS IN THE MAINTENANCE SECTION OF
THIS SERVICE MANUAL. USE OF UNAUTHORISED PARTS OR FAILURE TO
FOLLOW MAINTENANCE INSTRUCTIONS MAY CREATE A RISK OF
ELECTRIC SHOCK OR INJURY.
Содержание CS48
Страница 1: ...OPERATION MAINTENANCE INSTRUCTIONS LS1114 BELT DISC SANDER MODEL NO CS48 PART NO 6500430...
Страница 20: ......
