Clarke CS48, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 20

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
SURFACE SANDING ON THE BELT
When sanding flat wide surfaces hold
the work tightly to the surface of the
belt and against the belt sander
table. Keep your fingers away from
the sanding belt and use a push or
hold-down stick if possible.
• Exercise extra care when
working with very thin pieces.
• Only apply sufficient pressure to
allow the sanding belt to remove material.
SANDING INSIDE CURVES
You can sand inside-curves using the
idler drum end of the belt.
• Hold the work tightly.
• Keep fingers away from the
sanding belt.
• Keep the curve held against the
idler drum, moving the work
gradually back and forth across
the drum.
SANDING OUTSIDE CURVES
• Keep the curve pressed against
the sanding belt, moving the
work from left to the right of the
belt.
• Make sure that you hold the
work tightly against the surface
of the table.