Clarke CR 28 Boost, Руководство по обслуживанию

Страница: 55 / 72

ENGLISH
Service Manual - CR 28 BOOST
®
53
ELECTRICAL SYSTEM
MACHINE WORKING HOUR CHECK
Turn.the.ignition.key.(A).to."I".
In the first 5 seconds of machine operation, the display (B) shows the total number of working hours (scrubbing/drying)
performed.by.the.machine.
Turn.the.ignition.key.(A).to."0".
HOUR COUNTER RESET PROCEDURE
NOTE
Perform this procedure only in case this cannot compromise warranties or scheduled maintenance intervals.
Turn.the.ignition.key.(A).to."0".
Press.and.hold.the.switch.(C).and.turn.the.ignition.key.(12).to.“I”.
Press.and.hold.the.switch.(C).until.the.working.hours.are.shown.on.the.display.(B).(after.15.seconds.approximately).
Press.and.release.the.switch.(C).5.times,.within.5.seconds.
The.hour.counter.is.reset.
B
A
C
S301356C
BATTERY MAINTENANCE AND RECHARGING
See.the.User.Manual.
BATTERY DISASSEMBLY/ASSEMBLY
Disassembly
Drive.the.machine.to.the.appointed.disposal.area,.and.empty.the.recovery.water.tank.(58).with.the.hose.(22).
Empty.the.solution.tank.(59).with.the.tap.(36).
Drive the machine on a level floor.
Turn.the.ignition.key.(12).to."0".
Carefully.lift.the.tank.assembly.(60).to.reach.the.batteries.
Disconnect.the.battery.connector.(63).
Disconnect.the.battery.terminals.(61).
Remove.the.batteries.(61).
If.necessary,.remove.the.battery.case.(62).
Assembly
Assemble.the.components.in.the.reverse.order.of.disassembly,.and.note.the.following:
If.a.battery.box.is.installed,.place.it.on.the.left.side.of.the.machine,.to.allow.the.tank.assembly.(60).to.be.closed.correctly.
1.
2.
3.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
•