MAINTENANCE
It is important to clean the complete unit thoroughly at the end of any operation.
1.
Turn OFF air to the container.
2.
Turn the air exhaust valve knurled ring nut anticlockwise and allow the
container to completely depressurise.
3.
Loosen all lid wing nut securing nuts, swing back the bolts and move the lid so
that it rests at one side of the container.
4.
Hold the spray gun and hose above the level of the unit and pull the spray
gun trigger to allow paint in the hose to drain back into the container. The
paint cock should be open (where fitted).
5.
Empty the container of paint, then clean it thoroughly with solvent or white
spirits etc., depending upon the type of paint being sprayed.
Clean and dry all components that have come into contact with paint -
agitator etc.
6.
With the container and other components cleaned thoroughly, pour clean
solvent or other cleaner, into the container.
7.
Replace the lid and tighten the wing nuts - progressively.
8.
Turn ON the air to the container and pull the spray gun trigger. Keep it pressed
until only clean solvent or other cleaner is ejected from the spray gun.
9.
Repeat steps 1 - 4 to allow solvent or other cleaner to drain back into the
container.
10
Finally empty the container and dry all components thoroughly,
Store in a clean dry place, with all cocks closed, and the lid loose.
Periodically, pressurise the container to 5.5bar in order to test the safety valve.
If it does not blow off at this pressure, do not use the appliance...have the Pressure
Relief Valve replaced.
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
PARTS & SERVICE CONTACTS
6
Содержание CPP11
Страница 8: ...Parts Diagram CPP 11 8...
Страница 10: ...Parts Diagram CPP 30 40 10...
