Clarke cp185, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 16

9
Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATION
• Whether polishing or sanding, always ensure the workpiece is securely
fixed, i.e. clamped to a workbench or secured in a vice.
• When working on car bodywork, the vibration may cause any items left on
the car bonnet, boot or roof. to fall onto the rotating disc and be thrown,
leading to injury to yourself or others in the work vicinity. Always keep the
work area tidy.
1. Hold the sander/polisher firmly with both hands and switch on. The motor
will then run. Press and hold the trigger lock button whilst holding the
trigger in and the tool will run continuously. To release the button, squeeze
the trigger, then release and the motor will stop.
2. Adjust the speed control to the desired working speed.
3. Slowly apply the sander/polisher to the workpiece and proceed to sand or
polish. Move the disc across the work applying a light even pressure.
WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT
CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL.
• If it is necessary to change the speed, always lift the disc from the work
surface, adjust the speed control to the required speed then reapply to
the work surface and continue as before.
4. On completion, lift the sander/polisher from the work surface and release
the trigger.
WARNING: THE DISC WILL CONTINUE TO ROTATE FOR A FEW SECONDS
AFTER THE TRIGGER HAS BEEN RELEASED.
• Ensure the motor has come to a complete stop before setting the tool
down on the workbench etc. Failure to do so can cause the tool to be
thrown, resulting in damage to the tool or personal injury.