Clarke CONTRACTOR CON1450WC, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 16

8
REPLACING THE CUTTING DISCS
NOTE: Always replace both discs at the same time.
1.
Side plate
Remove the depth adjustment
knob by hand and 3 bolts
indicated using the 5mm hex key
supplied.
2. Lift off the side plate.
3. Press and hold the spindle lock
button.
4. Use the Pin Spanner supplied to
release the outer flange
SETTING THE CUTTING WIDTH
The cutting width is determined by
the number of spacer discs you put in
between the discs.
• The cutting width is equal to:
The thickness of the 2 blades (2
x 2.5 mm) + the thickness of the
spacers.
• Make sure that the inner flange
is seated properly and the flat
section has engaged with the
flat part at the base of the spindle.
NOTE: All spacers must be used to prevent the blades from wobbling.
simply place the spacers on the outside of the cutting discs to
make the cutting width narrower.
5. Replace the side plate and secure with the depth adjustment knob and 3
bolts you removed in step 1.
WARNING: Disconnect the plug from the power source before making
any adjustments or changing accessories.