6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ANGLE GRINDER SAFETY INSTRUCTIONS
1.
Before starting work, always consider the following:
The use of hand held
angle grinders for grinding and cutting operations can present risks to the
user. Full observation of the safety instructions in this user guide is essential.
2.
Before undertaking grinding or cutting operations, always consider the
following:
Is the grinding/cutting work necessary? Could a different tool be
used with less risk? (e.g. a fixed controlled cutting/grinding machine). Can
the work be sensibly positioned, secured and accessed so the operator
can maintain adequate control of the tool, taking into account, for
example the possible hazards associated with potential snatch/jamming of
a cutting disc. Is the cutting task too large for a hand held tool? If in doubt,
use an alternative lower risk solution or refer to qualified trade personnel.
3.
Always use the correct tool for the job.
Always assess the job. You should
never force a small angle grinder to do the job of a heavy tool. Do not use
tools for purposes not intended.
4.
Always position the power cable clear of the spinning disc.
If you loose
control, the cable may be cut or snagged and you hand drawn onto the
spinning disc.
5.
Start up speed.
Always allow the angle grinder to run up to full operating
speed before applying it to the job.
6.
Applying the disc to the workpiece.
Never bump the angle grinder disc on
the workpiece, or let the disc hit any other objects while grinding.
7.
Do not abuse the mains lead.
Never carry the tool by the mains lead or pull
it to disconnect it from the mains socket. Keep the mains lead away from
heat, oil and sharp edges.
8.
Secure the work.
Use clamps, or vices to hold the workpiece. Failure to
secure the workpiece could result in serious injury.
9.
Remove adjusting keys and wrenches.
Form the habit of checking to see
that keys and adjusting wrenches are removed from the tool before
turning it on.
10.
Use outdoor extension leads.
When the tool is used outdoors, only use
extension leads intended for outdoor use. Always make sure that the
extension lead is correctly rated.
11.
Check damaged parts.
A guard or other parts that are damaged should
be properly repaired or replaced, by an authorised service centre, unless
otherwise indicated in this user guide. Have defective switches replaced
by an authorised service facility.
