15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SUITABLE ABRASIVE AND CUTTING DISCS
The following Clarke discs are suitable for use with the CON1050B. Always use
the correct disc and guard type for its intended task.
MAINTENANCE
GENERAL MAINTENANCE
1. Always have your angle grinder inspected and maintained by qualified
service personnel. Do not attempt to repair the angle grinder unless you
are qualified to do so.
2. Make sure that all nuts, bolts and screws are tight and secure.
3. Check the side handle and the guard for damage.
4. Always have any damaged, or worn parts repaired or replaced.
5. Ensure the grinding wheel or cutting disc is perfectly sound, free from
cracks or damage.
6. Inspect the power cable to ensure it is sound and free from cracks or bare
wires etc.
CLEANING
To maintain the best possible performance from your angle grinder, it must be
kept clean.
1. Ensure all air ventilation slots are clear, (use compressed air to clean the
machine if possible. Always wear protective goggles when cleaning with
compressed air).
2. Clean the exterior of the machine with a soft cleaning cloth. Never use any
chemicals or harsh abrasives. Avoid using solvents when cleaning plastic
parts, which may be susceptible to damage from various types of
commercial solvents.
Use
Model No
Diameter
Bore
Part No
Cutting & Grinding
PD1 (plasma) 115mm
22mm
3052050
Metal Cutting
-----------------
115mm
22mm
6470775
Metal Grinding
-----------------
115mm
22mm
6470705
Masonry Cutting
-----------------
115mm
22mm
6470735
