Clarke Contractor CFN34, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 11

8
Clearing a jam
To clear a jammed nail, proceed as follows:
1. Follow the compressor procedure to switch off
and release the air pressure.
2. Disconnect the air supply hose.
3. Pull the nail pusher back as far as possible until
the catch clicks into place.
4. Remove the nails from the magazine.
• The jammed nail should then release. If the
jammed nail does not release, proceed as
follows.
5. Remove the bolt indicated using the hexagonal
key supplied.
6. Remove the striker cover.
7. Remove the jammed nail using pliers or similar tool.
8. Replace the striker cover.
Avoid triggering the nailer when the nail magazine is empty. If the nailer operates
improperly or is defective, disconnect from the air supply and have the tool inspected by
a qualified service technician.
In the event of long breaks in work or at the end of the working session, disconnect the
tool from the air supply and empty the nail magazine.
Disconnecting the air supply
WARNING! NEVER DISCONNECT THE AIR SUPPLY HOSE UNTIL THE COMPRESSOR
HAS BEEN SHUT DOWN AND THE COMPRESSED AIR RELEASED.
1. Refer to the compressor instruction book for the procedures to shut down and
release the compressed air.
2. Once the pressure has been released, disconnect the air supply hose from the nail
gun. Slide the collar on the hose connector away from the nailer. The hose will
release and spring backwards.
3. Remove any nails remaining in the magazine of the nailer .
4. Store the nailer safely in its box in a dry, secure environment