12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING/ADJUSTING THE DISC GUARD
1. Slide the disc guard into place as
shown.
2. Rotate the disc guard to the
required position and secure by
tightening the screw.
3. Ensure the disc guard is securely
fitted before using the grinder.
FITTING/REMOVING A DISC
Make sure the correct disc guard is
fitted before you fit any cutting or
grinding disc.
1. Press and hold the spindle lock
button.
• You will need to turn the spindle
by hand to fully engage the
spindle lock.
2. Use the pin spanner supplied to
remove the outer retaining disc.
3. Ensure the inner retaining disc is fitted correctly, with the raised “flats” on
the inner side engaging with the corresponding flat section on the spindle.
4. Place the grinding disc over the spindle and on top of the inner retaining
disc.
• If the grinding discs supplied is a depressed centre type, mount it as
shown, i.e. with the depressed centre (printed side) towards the
machine.
WARNING: MAKE SURE THAT THE ANGLE GRINDER IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
ANY ACCESSORIES. ENSURE THE CORRECT GUARD IS FITTED FOR THE DISC
BEING USED.
WARNING: THE DISC GUARD SHOULD BE FITTED SO THAT IT PROVIDES
MAXIMUM PROTECTION TO THE USER WHEN IN THE WORKING POSITION.
WARNING: MAKE SURE THAT THE ANGLE GRINDER IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
ANY ACCESSORIES.
