20
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5. Push and hold down the blade
lock.
6. Use a hex wrench to undo and
remove the centre screw.
• The screw has a
LEFT HAND THREAD (turn it CLOCKWISE to undo).
7. Pull off the outer flange followed by the saw blade.
NOTE:
You should take this opportunity to thoroughly clean parts previously
inaccessible.
8. Replace the blade, ensuring it has the correct diameter and bore.
• Make sure that the teeth point down at the front.
• Please note that spare blades are available from Clarke
International. Please see your Clarke dealer.
9. Replace the outer flange (marked with an ‘O’) and screw in the centre
screw, remembering the screw has a LEFT HAND THREAD (turn it
ANTICLOCKWISE to tighten).
CHANGING THE CARBON BRUSHES
A spare pair of carbon brushes are supplied with the machine. Should it
become necessary to change these:
1. Unscrew the brush holder cap.
2. Pull out the worn brushes.
3. Replace with new brushes.
• Always replace the brushes in
pairs.
4. Replace the brush holder cap,
taking care not to cross thread it.
WARNING: NEVER PUSH THE
BLADE LOCK IN WHEN THE
MOTOR IS RUNNING.
WARNING: MAKE SURE THAT THE SAW IS SWITCHED OFF AND UNPLUGGED
FROM THE MAINS SUPPLY BEFORE CHANGING THE CARBON BRUSHES.
