7
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
PRINCIPAL OF OPERATION
The Clarke clutch & brake bleeding kit is designed for one-man operation. It is
used to drain brake fluid from a hydraulic system such as the clutch or brake
systems on an vehicle. It can also be used to extract a variety of fluids from
reservoirs including the master cylinders or those for power steering fluid.
It uses a normal workshop compressed air supply between 70 to 170 psi (4.8-
11.6 bar), to create a vacuum in the tank. The vacuum can be connected
by attaching the adapter to the fluid inlet plug located on the top of the unit.
The automatic refill bottle is designed for use with a standard bottle of brake
fluid, to maintain an adequate fluid level in the master cylinder while the
hydraulic system is bled. The bleeder air inlet will shut off automatically when
the hydraulic fluid reaches the maximum level.
OPERATING INSTRUCTIONS
IMPORTANT:
In addition to this manual, always follow the manufacturers recommended
procedures when servicing each vehicle.
REMOVING OLD HYDRAULIC FLUID FROM THE MASTER CYLINDER
1. Park the vehicle securely on level
ground with the engine off.
2. Clean the outside of the master
cylinder and master cylinder cap
to prevent dirt entering the
master cylinder when the cap is
removed.
3. Remove the cap from the master
cylinder reservoir.
4. Connect compressed air supply
to the Air Inlet Valve (I).
I
Содержание CHT637
Страница 16: ......
