DUST EXTRACTION
The sander is provided with a dust extraction facility, where a dust bag or vacuum extractor
may be connected to the right hand side of the machine. An adapter is provided for this
purpose. Please note however, that this does not preclude the user from wearing a face
mask to prevent the inhalation of dust particles.
It is an EEC requirement that a dust extraction facility be provided on power tools, however,
due to the nature of the tool, some of the dust produced will be forced into the surrounding
atmosphere, and will not be collected.
Additionally, please keep these instructions in a safe place for future reference.
14. ALWAYS
wear proper apparel. loose clothing or jewellery may
get caught in moving parts. wear protective hair covering to
contain long hair.
15. ALWAYS
use recommended accessories. the use of improper
accessories could be hazardous.
16. ALWAYS
remove plug from electrical outlet when adjusting,
changing parts, or working on the machine.
17. NEVER
operate machine while under the influence of drugs, alcohol or any medication.
18. NEVER
leave machine running unattended. turn power off.
Do not leave the machine until it comes to a complete stop.
19. NEVER
force the machine. it will do a better and safer job at
the rate for which it was designed.
20. NEVER
use power tools in damp or wet locations or expose
them to rain. Keep your work area well illuminated. do not
use in explosive atmosphere (around paint, flammable liquids
etc.). Avoid dangerous environment.
Additional Precautions For Power Planers
1.
ALWAYS
wear ear protectors/defenders as the noise level of this machine can exceed
85dB (A).
2.
ALWAYS
keep the mains cable well away from the machine and ensure an adequate
electrical supply is close at hand so that the operation is not restricted by the length
of the cable.
3.
ALWAYS s
witch the machine OFF immediately the task is completed.
4.
ALWAYS
Ensure the blades are fully tightened before use.
5.
NEVER
allow the ventilation slots in the machine to become
blocked.
6.
NEVER
leave the cutter wrench in the planer.
7.
DO NOT
use the machine if the electric cable, plug or motor is
in poor condition.
8.
When doors etc. are to be planed, ensure all nails have been
removed beforehand. Nails will damage blades.
9.
Workpiece should always be firmly clamped to workbench
etc.
- 3 -
