7
C. Battery Charging
When plugging the battery into the
charger please note that it will fit one
way only...DO NOT FORCE it .
When it is correctly plugged in, the
battery should sit as shown in the
illustration opposite.
Install the battery in the charger, then
plug the charger into the mains and
switch ON (at the mains).
The LED (arrowed) will immediately
illuminate RED.
When the battery is fully charged, the
LED will turn GREEN. At this point,
switch OFF and disconnect the
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.
non-rewirable) please note:
1.
The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
5.
The fuse in the plug must be replaced with one of the same rating (5 amps)
and this replacement must be ASTA approved to BS1362. If in doubt, consult
a qualified electrician.
If the battery is not to be fitted immediately, ensure that the metal contacts are
protected so as to avoid the possibility of a short circuit which would cause damage.
Remember to avoid extremes of heat or cold when charging.
NOTE:
Ni-Cad batteries as used in Clarke Cordless Drills should be given a full charge
when first supplied new. Maximum battery performance will be achieved after
approximately 5 complete charge/discharge cycles.
The battery should be fully discharged before recharging....see important notice
- page 7.
charger at the mains . Remove the battery and install in the drill.
NOTE: A complete charge will take approx. 1 hour, depending upon the state of
the battery.
6
