3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
1.
Slide the lower column into the
base.
2. Secure in place using the spring
washer and bolt as shown on the
right.
USING THE AXLE STANDS
1.
Refer to the vehicle handbook for the
correct jacking procedure and
location of support points.
2. Raise the vehicle using a suitable lifting
jack.
ADJUSTING THE AXLE STANDS
1. Remove the locking pin (if fitted).
2. Raise the upper column to the
required height and replace the
locking pin.
3. Position the axle stand under a
suitable supporting point. See your
vehicle manual for the location.
WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY
PART OF THE AXLE STAND, IF THERE IS, DO NOT USE.
WARNING: DO NOT EXCEED THE RATED LOAD OF 3 TONNE PER PAIR OR
1.5 TONNE PER STAND.
WARNING: IT MUST BE ENSURED THAT THE VEHICLE/LOAD IS CAREFULLY
LOCATED ONTO THE CENTRE OF THE AXLE STAND SADDLE. FAILURE TO DO
THIS CAN RESULT IN DAMAGE TO THE AXLE STANDS, LOSS OF SUPPORT TO
THE LOAD, SERIOUS PERSONAL INJURY OR LOSS OF LIFE.
