8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING THE HANDLE
The CAT60 is supplied with an auxiliary
handle. To install it proceed as follows.
1. Slide the clamping ring over the
body of the drill., ensuring it rests
on the flat shoulder provided.
2. Screw the handle onto the
threaded part of the clamping ring
until the handle assembly is tight.
• The handle can be located at
any position around the drill by
loosening the handle grip and adjusting the position.
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by gripping
the chuck key in one of the holes
in the chuck and turning it as
shown.
2. Make sure that the head of the
chuck key is located on the barrel
of the chuck.
3. Turn the chuck key until the chuck
jaws are open sufficiently to take
the drill bit.
4. Place the drill bit in the jaws of the
chuck as far as it will go.
5. Close the chuck jaws and tighten
to grip the drill bit by turning the
chuck key as shown.
6. Make sure that the chuck jaws are
fully closed and that the drill bit is
held firmly.
7. Your air drill is now ready for use.
Drill bit
Chuck jaws
Close
Open
Chuck
key
jaws
jaws
Barrel
