11
Parts & Service: 020 8988 7400/E-mail: [email protected] or [email protected]
MAINTENANCE
WARNING! MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR
SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
DAILY
•
Drain water from the compressor
air tank and air-line.
•
Pour a few drops of CLARKE air
line oil** into the air inlet. This
should be carried out regardless
of whether or not an air line
lubricator is used. If a lubricator is
not used, this procedure should
be repeated after every two to
three hours of use.
WEEKLY
•
Check the air inlet screen filter shown in Fig 4 and clean if necessary.
CLEANING
•
Keep the body of the tool clean and free from debris. Grit or gum deposits
in the tool may reduce efficiency.
•
After extensive use, remove the inlet screen filter and flush out the
mechanism with gum solvent oil or an equal mixture of SAE No10 oil and
paraffin. Allow to dry before use.
SERVICE AND REPAIR
•
Any major servicing and repairs should be carried out by your local
CLARKE dealer or a qualified service technician.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture, or restrictions in the line, or the use of connectors of improper size or
poor condition which will reduce air supply.
**Clarke Airline Oil is available from your CLARKE dealer: part no 3050825.
Air Inlet Screen
Filter (located
here)
Содержание CAT32B
Страница 16: ......
