Clarke CAT191, Инструкция по эксплуатации и обслуживанию

Страница: 6 / 8

6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
DISASSEMBLY
1. The filter/regulator can be disassembled without removal from air line.
2. Shut off the inlet pressure. Reduce pressure in inlet and outlet lines to zero.
3. Turn the adjustment knob fully anti-clockwise.
4. Remove the bowl by pushing into the body and turning counterclockwise.
5. Disassemble in general accordance with the parts illustrated on page 7.
Do not remove the drain unless replacement is necessary. Remove and
replace only if the drain malfunctions or if converting to automatic drain.
CLEANING
1. Clean the plastic bowl with warm water only. Clean other parts with warm
water and soap.
2. Rinse and dry all parts. Blow out internal passages in the body with clean,
dry, compressed air. Blow air through the filter element from inside to
remove surface contaminants.
3. Inspect all parts and replace any found to be damaged.
ASSEMBLY
1. Lubricate all o-rings, adjusting screw threads and tip, outer circumference
and both sides of thrust washer, portion of the manual drain body that
contacts the bowl, hole in the manual drain body that accommodates the
stem of the drain valve and valve stem with o-ring grease.
2. Assemble as shown on page 7. Torque items listed inn the table..
3. Push the bowl into the body and turn fully clockwise.
Torque Settings
Part Inch Pounds (N-m)
Screw (a) & screw (b) 20 to 25 (2.3 to 2.8)
Screw (c) 17 to 22 (1.9 to 2.5)
Baffle 4 to 6 (0.5 to 0.7)
Centre post 6 to 8 (0.7 to 0.9)
Nut 20 to 25 (2.3 to 2.8)