12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
DAILY
1. Before use, drain water from the airline filter and compressor.
2. If no line lubricator or mini oiler is used, ensure that oil is applied to the tool
on a daily basis through the air inlet connection. Run a few drops of oil
through the tool before use. It may be entered into the tool air inlet,
(ensuring the strainer is clear), or into the hose at the nearest connection to
the air supply, or alternatively using the oil port in the side of the wrench.
After this you can operate the tool.
3. This procedure should be repeated after every two to three hours of use, or
at the start of the working day.
WEEKLY
1. Check the air inlet screen filter for
blockage and clean if necessary.
CLEANING & OVERHAUL
1. Grit or gum deposits in the tool
may reduce efficiency.
2. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of CLARKE air-
line oil and paraffin. Allow to dry before use.
3. If the tool still runs erratically or becomes inefficient, and the air supply is of
good quality, it may be necessary to dismantle the air motor and replace
worn or damaged parts. You may prefer to take the tool to your CLARKE
dealer if internal maintenance is required.
4. The air tool may be dismantled by unfastening the bolts and removing the
rear cover prior to replacing any worn or damaged parts.
5. While is a dismantled state, it may be desirable to grease the hammer
mechanism and applying a small amount of good quality bearing grease.
This may be better left to your CLARKE dealer.
WARNING: MAKE SURE THAT THE WRENCH IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
Содержание CAT117
Страница 16: ......
