Clarke CAT113, Руководство по сборке и инструкция

Страница: 5 / 12

5
AIR SUPPLY
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE THOROUGHLY FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE
USE OF COMPRESSORS AND COMPRESSED AIR SUPPLY.
The recommended
procedure to connect this
tool to an air supply, is
shown on the right.
We recommend that an
automatic in-line filter-
regulator-lubricator is used.
• It will keep the tool in
good condition. The in-line
lubricator should be regularly
checked and filled with air tool oil adjusted to 2 drops per minute.
AIR SUPPLY SAFETY
1. Ensure the trigger is in the OFF position before connecting to the air supply.
2. You will require an air pressure of 90 psi , with an air flow of at least 4 CFM.
WARNING! ENSURE THE AIR SUPPLY IS CLEAN AND DOES NOT EXCEED
90PSI WHILE OPERATING THE TOOL. TOO HIGH AN AIR PRESSURE AND
UNCLEAN AIR WILL SHORTEN THE PRODUCT LIFE DUE TO EXCESSIVE
WEAR, AND MAY BE DANGEROUS CAUSING DAMAGE AND/OR
PERSONAL INJURY.
3. Drain the compressor daily. Water in the air line could damage the cut off
tool.
4. Clean air inlet filter weekly.
5. Line pressure should be increased to compensate for unusually long air
hoses (over 8 metres). The hose diameter should be 3/8" Internal Diameter.
The pressure at the cut off tool should not be over 90 psi.
AIR HOSE
• The air hose must be rated at least 150% of the maximum operating
pressure of the tool.